Product Information for Cortex-M (ARMv6/7/8 32-bit) Debugger

The embedded tools company

Delete Order No. Quantity Description
Get Quote Refresh


add to cart

goto to cart
Supports Arm Cortex-M cores

trace support ETM Cortex-M via ETB included

20 pin Arm connector

supports 5-pin standard JTAG, cJTAG and
Serial Wire Debug Port, (0.4 V - 5 V)

includes software for Windows, Linux and MacOSX

requires Power Debug Module

cJTAG and SWD require
Power Debug Interface USB 2.0/USB 3.0,
Power Debug Ethernet, PowerTrace, Power Debug II
or PowerDebug PRO

Measuring Adapter JTAG 20

add to cart

goto to cart
Adapter to measure JTAG signals by a logic analyzer
or to disconnect single JTAG lines from the target

ARM Conv. ARM-20, MIPI-34 to Mictor-38

add to cart

goto to cart
Converter to connect the ARM Debug Cable or
the CombiProbe to a Mictor connector on the
target. This is needed if you want to debug
without a Preprocessor and if there is only
a Mictor connector on the target.
The trace signals of the CombiProbe are
connected to the lowest four trace signals of
the Mictor (ETMv3 pinout, continuous mode).
But tracing is normally no use case due to
the bandwidth limitations of the CombiProbe.

Conv. ARM-20 MIPI-20 to 10-pin ECU14

add to cart

goto to cart
ARM Converter ARM-20 or MIPI-20 to 10-pin ECU14

Converter AUTO26 to ARM20, ARM20-ETK or TI14

add to cart

goto to cart
Converter 26-pin Automotive Debug Cable
to ARM20 or TI14

Copyright © 2020 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany   Impressum     Privacy Policy
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 30-Jan-2020