TRACE32 Debugger for VR5500A, VR5701

Universal debug controller with
USB 3.0 for Windows/Linux/MacOSX

applicable for all TRACE32 debug cables

requires TRACE32 software DVD 2013/02 or newer

Universal debug controller,
1 Gbit Ethernet and
USB 3.0 (Windows/Linux/MacOSX)

supports NEC VR-Series with N-Wire

includes software for Windows, Linux and MacOSX

requires Power Debug Module

debug cable with 20 pin connector

requires LA-7936 if KEL connector is used on
the target

requires LA-7937 if Mictor connector is used on
the target

Universal Trace Port Controller,
512 MegaByte Trace Memory
Streaming rate up to 50 MByte/s

requires PowerDebug II Ethernet or PowerDebug PRO

Universal Trace Port Controller,
4 Giga Byte Trace Memory

includes logic analyzer with
17 digital channels, 1024 KSamples

requires PowerDebug II Ethernet or PowerDebug PRO

Host requirements:
USB 2.0 or 100/1000 MBit Ethernet interface,
1.0 GigaByte RAM

Preprocessor for VR with TRCU,
200 MHz clock speed, normal trace depth,
support 4 and 16 bit bus width

Mictor connector to target

requires LA-7938 if KEL connector is used on
the target

voltage range 1.8V to 5.5V

Converter KEL connector to debug cable

Converter from 20 pin male connector of

LA-7835 (N-Wire Debugger for V850)
LA-7842 (N-Wire Debugger for NEC VR-Series)

to Mictor38

Adapter 20 pin 100 mil to 50 mil with cable.
Purpose: Use 20-pin Debug Cable with smaller target
connector. In case of ARM Debug Cable better use
MIPI-10 or MIPI-20 for new designs.

Converter KEL connector to preprocessor