TRACE32 Debugger for MIPSM14K, MIPSM14KC, MIPSM4K

Universal debug controller with
USB 3.0 for Windows/Linux/MacOSX

applicable for all TRACE32 debug cables

requires TRACE32 software DVD 2013/02 or newer

Universal debug controller,
1 Gbit Ethernet and
USB 3.0 (Windows/Linux/MacOSX)

Universal Trace Port Controller,
8 Giga Byte Trace Memory

requires PowerDebug II Ethernet or PowerDebug PRO

supports MIPS32 4Kp, 4Km, 4Kc derivatives
and LEXRA LX4280

includes software for Windows, Linux and MacOSX

requires Power Debug Module

debug cable with 14 pin connector

supports MIPS32 4Kp, 4Km, 4Kc derivatives
and LEXRA LX4280

please add the base serial number of your debug
cable to your order

1.) Support for EJTAG onchip trace on MIPS32
please add the base serial number of your debug
cable to your order

2.) Supports 4-Bit IFlow program trace by using
LA-4504 CombiProbe MIPS32-Debugger and 4-Bit IFLOW

Universal Trace Port Controller,
512 MegaByte Trace Memory
Streaming rate up to 50 MByte/s

requires PowerDebug II Ethernet or PowerDebug PRO

Universal Trace Port Controller,
4 Giga Byte Trace Memory

includes logic analyzer with
17 digital channels, 1024 KSamples

requires PowerDebug II Ethernet or PowerDebug PRO

Host requirements:
USB 2.0 or 100/1000 MBit Ethernet interface,
1.0 GigaByte RAM

Converter for MIPS-EJTAG 14 pins to 12 pins
to support Micronas MDE processor

Converter for MIPS-EJTAG 14 pins to 24 pins
to support IDT processors

IMPORTANT:
This adpater can also be used for 20 pin
target connections, but a separate wire for
VCC is required. Please ask your local
distributor.

Converter to connect a MIPS Debug Cable to an ARM-20 connector
on the target

Converter to connect a Debug Cable to 10/20/34 pin
connectors specified by MIPI.

Debug cable and 128-MByte of trace memory

requires the following A-license:
LA-7760A (JTAG Debugger for MIPS32)

4-Bit IFlow program trace requires:
LA-7971X (Trace License for the MIPS32)

requires Power Debug Interface USB 2.0/USB 3.0,
Power Debug Ethernet, PowerTrace, Power Debug II
or Power Debug PRO

5V tolerant inputs; max. output level 3.3V