TRACE32 Debugger for MDEB, MDED

Universal debug controller with
USB 3.0 for Windows/Linux/MacOSX

applicable for all TRACE32 debug cables

requires TRACE32 software DVD 2013/02 or newer

Universal debug controller,
1 Gbit Ethernet and
USB 3.0 (Windows/Linux/MacOSX)

supports MIPS32 4Kp, 4Km, 4Kc derivatives
and LEXRA LX4280

includes software for Windows, Linux and MacOSX

requires Power Debug Module

debug cable with 14 pin connector

Universal Trace Port Controller,
512 MegaByte Trace Memory
Streaming rate up to 50 MByte/s

requires PowerDebug II Ethernet or PowerDebug PRO

Universal Trace Port Controller,
4 Giga Byte Trace Memory

includes logic analyzer with
17 digital channels, 1024 KSamples

requires PowerDebug II Ethernet or PowerDebug PRO

Host requirements:
USB 2.0 or 100/1000 MBit Ethernet interface,
1.0 GigaByte RAM

Preprocessor for Real-Time Trace of MIPS32

EJTAG 2.6 derivatives or higher

600 MBaud (300MHz clock speed, DDR)
Variable threshold level and termination voltage,
AUTOFOCUS self calibration technology,
Supports 1.2 to 3.3V - otherwise contact support

Requires PowerTrace
(PowerTrace Ethernet Version 6 or higher)

voltage range 1.2V to 3.3V

Converter for Preprocessor for MIPS
Mictor38 to Samtec52
to support Micronas MDED (Lexra LX4280) processor

Target connector:
FTSH-126-04-L-DV (SMD, small height)
FTSH-126-04-L-D (through-hole, small height)

FW-26-05-L-D-XXX-150
(SMD, "XXX" selectable height)

FW-26-02-L-D-XXX-150
(through-hole, selectable height)

Converter for MIPS-EJTAG 14 pins to 12 pins
to support Micronas MDE processor

Converter for MIPS-EJTAG 14 pins to 24 pins
to support IDT processors

IMPORTANT:
This adpater can also be used for 20 pin
target connections, but a separate wire for
VCC is required. Please ask your local
distributor.

Converter for Preprocessor for MIPS
Mictor38 to Samtec52
to support Micronas MDEB (Lexra LX4280) processor

Target connector:
FTSH-126-04-L-DV (SMD, small height)
FTSH-126-04-L-D (through-hole, small height)

FW-26-05-L-D-XXX-150
(SMD, "XXX" selectable height)

FW-26-02-L-D-XXX-150
(through-hole, selectable height)

Converter to connect a MIPS Debug Cable to an ARM-20 connector
on the target

Converter for Preprocessor for MIPS
Mictor38 to Samtec52
to support Micronas MDED (Lexra LX4280) processor

Target connector:
FTSH-126-04-L-DV (SMD, small height)
FTSH-126-04-L-D (through-hole, small height)

FW-26-05-L-D-XXX-150
(SMD, "XXX" selectable height)

FW-26-02-L-D-XXX-150
(through-hole, selectable height)

Converter to connect a Debug Cable to 10/20/34 pin
connectors specified by MIPI.