TRACE32 Debugger for IMX285

Universal Trace Port Controller,
8 Giga Byte Trace Memory

requires PowerDebug II Ethernet, PowerDebug PRO
or PowerDebug X50
and TRACE32 software DVD 2021/02 or newer

supports Arm9

IDC20A debug cable supports 5-pin standard JTAG, cJTAG and
Serial Wire Debug Port, (0.4V - 5V)

includes software for Windows, Linux and MacOSX

cJTAG and SWD require
Power Debug Interface USB 2.0/USB 3.0,
Power Debug Ethernet, PowerTrace, Power Debug II
PowerDebug PRO, PowerDebug E40 or PowerDebug X50

Parallel preprocessor for Arm/Cortex
Embedded Trace Macrocell (ETM),
Program Trace Macrocell (PTM)

Connector cable and software,
Variable threshold level and termination voltage,
AUTOFOCUS self calibration technology,
Support all ETM modes, with 2 MICTOR connectors,

Voltage: 1.2 to 3.3V - else contact support
Traceport: 1-32bit
Bandwidth: 9.6 Gbps (300MHz clock speed, DDR)
Connector: 2x38 pin mictor connector

Requires PowerTrace II / III, PowerTrace PX
or PowerTrace/Ethernet Version 6 or higher

eXtended connectivity line universal debug controller
with 1 Gbit Ethernet and
USB 3.0 for Windows/Linux/MacOSX

can be used for TRACE32 Debug Cable and
for the TRACE32 CombiProbe

requires TRACE32 software DVD 2022/09 SP2 or newer

Universal Trace Port Controller,
1 GByte Trace Memory
Streaming rate up to 100 MByte/s

requires PowerDebug II Ethernet, PowerDebug PRO
or PowerDebug X50
and TRACE32 software DVD 2022/02 or newer

Converter to connect an IDC20A Debug Cable
to a MIPS-14 connector on the target

Former name: Converter ARM-20 to MIPS-14

Converter to connect the IDC20A Debug Cable to a Mictor
connector on the target providing both debug and
trace signals. This is needed if you want to connect
the Debug Cable without a Preprocessor and if there
is only a Mictor on the target.

Former name: ARM Converter ARM-20 to Mictor-38

Converter to connect an IDC20A Debug Cable to a TI-14
connector which is used on many targets with
processors from Texas Instruments

Former name: Converter ARM-20 to TI-14

Converter to connect a Debug Cable to a TI-14 or
TI-20-Compact connector which is used on many
targets with processors from Texas Instruments

Former name: Converter ARM-20 to TI-14 or TI-20-Compact

Converter to connect a 20-pin debug cable to 10/20/34 pin
connectors specified by MIPI

Former name: Converter ARM-20 to MIPI-10/20/34 Arm/RISC-V

Converter to connect an Arm Debug Cable V1 (ARM-14)
to IDC20A or to connect a newer IDC20A Debug Cable
to ARM-14 target connector

ARM-14 is an obsolete connector specification,
do not use for new designs

Former name: ARM Converter ARM-20 to/from ARM-14

Adapter 20 pin 100 mil to 50 mil with cable