TRACE32 Debugger for AT91SAM9G45

supports ARM9 (0.4 V - 5 V)

supports 5-pin standard JTAG, cJTAG and
Serial Wire Debug Port

includes software for Windows, Linux and MacOSX

requires Power Debug Module

cJTAG and SWD require
Power Debug Interface USB 2.0/USB 3.0,
Power Debug Ethernet, PowerTrace, Power Debug II
or PowerDebug PRO

Universal debug controller with
USB 3.0 for Windows/Linux/MacOSX

can be used for all TRACE32 Debug Cable and
for the TRACE32 CombiProbe

requires TRACE32 software DVD 2013/02 or newer


Includes
LA-1952 Wall Mount Power Supply
LA-1942 USB-2 Cable
LA-1943 USB-3 Cable
LA-7411 Trigger Connector for PowerTools

Universal debug controller,
1 Gbit Ethernet and
USB 3.0 (Windows/Linux/MacOSX)


Includes
LA-1955 Desktop Power Supply
LA-1942 USB-2 Cable
LA-1943 USB-3 Cable
LA-7411 Trigger Connector for PowerTools

supports ARM9

requires a valid software guarantee or a valid
software maintenance key

please add the serial number of the base debug
cable to your order

Converter to connect an ARM Debug Cable to a MIPS-14 connector
on the target

Converter to connect the ARM Debug Cable to a Mictor
connector on the target providing both debug and
trace signals. This is needed if you want to connect
the Debug Cable without a Preprocessor and if there
is only a Mictor on the target.

Converter to connect a Debug Cable to a TI-14
connector which is used on many targets with
processors from Texas Instruments

Converter to connect a Debug Cable to a TI-14 or
TI-20-Compact connector which is used on many
targets with processors from Texas Instruments.

Converter to connect a 20-pin debug cable to 10/20/34 pin
connectors specified by MIPI


Includes
LA-1937 MIPI-Half-Size-Cable 34-10
LA-1938 MIPI-Half-Size-Cable 34-20
LA-1939 MIPI-Half-Size-Cable 34

Converter to connect an ARM Debug Cable V1 (ARM-14)
to ARM-20 or to connect a newer ARM Debug Cable
(ARM-20) to ARM-14 target connector

ARM-14 is an obsolete connector specification,
do not use for new designs

Converter to connect two ARM Debug Cable to one
connector on the target.

Old method to handle multicore debugging by using
two debugger hardware modules.

Galvanic isolation
for ARM debug cable
for automotive debug cable

Components rated to IEC60950-1 (600 V working voltage)

requires
Power Debug Interface USB 2.0/USB 3.0,
Power Debug Ethernet, PowerTrace, Power Debug II
or PowerDebug PRO

Adapter 20 pin 100 mil to 50 mil with cable.
Purpose: Use 20-pin Debug Cable with smaller target
connector. In case of ARM Debug Cable better use
MIPI-10 or MIPI-20 for new designs.


Includes
LA-2111 Half-Size-Cable 20