News - Software Debugging over the XCP Protocol


The embedded tools company






Höhenkirchen-Siegertsbrunn, 28-Sep-2018


Vector and Lauterbach Present a Development Solution for Software Debugging over the XCP Protocol

Stuttgart/Höhenkirchen-Siegertsbrunn, 2018-10-01 – Vector and Lauterbach are offering an integrated solution for ECU software development based on the new ASAM standard “Software Debugging over XCP”. It eliminates the need to repeatedly switch between hardware for measurement, calibration, and debugging.

The ECU debug connector can be a challenge to access in the vehicle and does not lend itself to the frequent disconnect/reconnects necessary when switching between MC and debug tools. By working together, Vector and Lauterbach are responding to the requirement of the automotive industry for concurrent use of the interface, and they are providing uniform access to the ECU for measurement, calibration and debugging purposes. This work is based on the new ASAM standard “Software Debugging over XCP” which was released in November 2017, and both partners were active participants in its development.

The VX1000 measurement and calibration hardware from Vector enables accessing internal data of development-level ECUs and near-production ECUs. Data rates of more than 100 MByte/s can be achieved over the entire automotive temperature range in test vehicles. The XCP slaves of the VX1000 hardware enable connection to the CANape measurement and calibration tool or to other tools with a standard-compliant XCP master. Such an XCP master is Lauterbach's TRACE32 debugger, which gets access – over the XCP slave – to the ECU and the debugging interface connected to it. This debugging configuration can operate without the need for any extension of the ECU software. Here, the TRACE32 XCP master provides the same debugging features as a hardware-based TRACE32 debugger.

“The interoperability of the Lauterbach debugger and the VX1000 and CANape measurement and calibration solutions from Vector together create significant added value for ECU developers. Previously, the two systems coexisted at workplaces. Not only can they be used cooperatively now, but they also extend the range of debugging applications to ECUs installed in the vehicle which have an integrated VX1000. This enables many new types of applications, simplifies handling and thereby saves valuable time in development and testing of ECU software,” says Dr. Ralf König, system architect for the Vector VX1000 measurement and calibration hardware.


Additional Information
Debugging via XCP



Copyright © 2018 Lauterbach GmbH, Altlaufstr.40, D-85635 Höhenkirchen-Siegertsbrunn, Germany   Impressum     Privacy Policy
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 28-Sep-2018