Debug Cable for STRED Architecture


The embedded tools company
Debugger
Target Connector 20 pin: Pinout
Target Connector 20 pin: 2.54mm Pin Dimension


Debug Cable for STRED Architecture


Order
Order
Information
Support
Technical Support
 
TOP

Debugger


This cable is used for the following processor architecture:

Order No.Probe
LA-2751Debugger for STRED (ICD) 


and supports a 0.4V to 5.2V.
 
TOP

Target Connector 20 pin: Pinout


Signal

Pin

 Pin

Signal

    
VREF-DEBUG12N/C
TRST-34GND
TDI56GND
TMS78GND
TCK910GND
RTCK1112GND
TDO1314GND
RESET-1516GND
N/C1718GND
N/C1920GND
    
Target connector, top-view

Note:
Pin 15 is open drain.
Pin2, Pin17 and Pin19 must under no circumstances be connected on the target side.
Otherwise the hardware of the debugger can get damaged.
 
TOP

Target Connector 20 pin: 2.54mm Pin Dimension


Target Connector Type

  • This is a standard 20 pin double row (two rows of 10 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 30.6mm/1.2".
  • Examples with housing: Samtec HTST-110-01-L-D (through-hole); Samtec HTST-110-01-L-DV (surface mount).
  • Examples without housing: Samtec TSW-110-23-L-D; Berg 67996-120H.




Copyright © 2018 Lauterbach GmbH, Altlaufstr.40, D-85635 Höhenkirchen-Siegertsbrunn, Germany   Impressum     Privacy Policy
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 28-Jun-2018