Adaptation for Xtensa


The embedded tools company
Debugger Adaptation for Xtensa
Connector 20-pin
Connector 14-pin




Support
Technical Support
 

Debugger Adaptation for Xtensa


Adaptation

The adaptation applies for the following TRACE32® products:

Order No.Probe
LA-3211Debugger for Xtensa® IDC20A (PACK) 
LA-3760JTAG Debugger for Xtensa 14 Pin out of production
LA-3762JTAG Debugger for Xtensa 20 Pin out of production
 

Connector 20-pin



Signal

Pin

 Pin

Signal

    
VREF-DEBUG12N/C
TRST-34GND
TDI56GND
TMS78GND
TCK910GND
RTCK1112GND
TDO1314GND
RESET-1516GND
N/C1718GND
N/C1920GND
    
Target connector, top-view

Note: Be careful with Pin17 and Pin19. They are intended to carry the signals DBGRQ and DBGACK, when the Xtensa core is embedded into an Arm based debug environment (see Adaptation for Arm Debug Connector). Do not connect Pin17 and Pin 19 on the target side in other cases. Otherwise the hardware of the debugger can get damaged. Pin 2, originally intended to supply debugger hardware with power, is not in use and should not be connected to the target hardware either. Termination circuitry on the debugger hardware makes sure that these pins are not floating.

Target Connector Type

  • This is a standard 20 pin double row (two rows of 10 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 30.6mm/1.2".
  • Examples with housing: Samtec HTST-110-01-L-D (through-hole); Samtec HTST-110-01-L-DV (surface mount).
  • Examples without housing: Samtec TSW-110-23-L-D; Berg 67996-120H.



Converter

Picture
Order No.
Probe
Converter IDC20A to XTENSA14
 

Connector 14-pin



Signal

Pin

 Pin

Signal

    
TDI12GND
TDO34GND
TCK56GND
N/C78KEY PIN
RESET-910TMS
VCCS1112N/C
N/C1314TRST-
    


Target Connector Type

  • This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".




Copyright © 2024 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany   Impressum     Privacy Policy
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 07-Mar-2024