Target Adaption for StarCore

Debugger Adaption for StarCore

Connector 20 pin (recommended for new designs)

Signal	Pin		Pin	Signal
VTREF	1		2	VSUPPLY (not used)
TRST-	3		4	GND
TDI	5		6	GND
TMS	7		8	GND
TCK	9		10	GND
RTCK	11		12	GND
TDO	13		14	GND
SRST-	15		16	GND
DBGRQ	17		18	GND
DBGACK	19		20	GND

Target Connector for Debugger Adaption for StarCore 20 pin

Dimension

Connector Type

• This is a standard 20 pin double row (two rows of 10 pins) connector (pin to pin spacing: 2.54mm/0.100").
• If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 30.6mm/1.2".

Connector 14 pin

Signal	Pin		Pin	Signal
TDI	1		2	GND
TDO	3		4	GND
TCK	5		6	GND
N/C	7		8	KEY
RESET-	9		10	TMS
VCCS	11		12	N/C
N/C	13		14	TRST-

Target Connector for Debugger Adaption for StarCore 14 pin

Dimension

Connector Type

• This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
• If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".

Adaption for StarCore on MICTOR

Layout

StarCore Connector pin-out Mictor38 (M38C) Debugger Combined Target Connector Signal Pin   Pin Signal         N/C 1 2 N/C N/C 3 4 N/C GND 5 6 MCKO DBGRQ 7 8 MRDY RSTIN- 9 10 EVTI- TDO 11 12 VTREF RTCK 13 14 N/C TCK 15 16 MDO07 TMS 17 18 MDO06 TDI 19 20 MDO05 TRST- 21 22 MDO04 MDO15 23 24 MDO03 MDO14 25 26 MDO02 MDO13 27 28 MDO01 MDO12 29 30 GND MDO11 31 32 EVTO- MDO10 33 34 MSEO1- MDO09 35 36 MSEO0- MDO08 37 38 MDO00         Connect Pin 39,40,41,42 and 43 to GND

Order No

AMP part numbers for suitable receptacles (for target)

AMP 2-5767004-2 RoHS compliant
AMP 2-767004-2
AMP 767054-1 (suggested by Motorola)
AMP 767061-1
AMP 767044-1 : Board-to-Board Type: Coplanar

Tyco Electronics

Probe

Probe dimensions

Half-Size Adapters

Half-Size Adapters for Debuggers

• 100 mil to 50 mil Adapters
• Small Footprint for Target Connector