Adaption for Renesas Electronics RL78 Debugger


The embedded tools company
Debugger Adaption for Renesas Electronics RL78 Debugger
Half-Size Adapters




Support
Technical Support
 
TOP

Debugger Adaption for Renesas Electronics RL78 Debugger


The debugger is connected via 14 pin double row connector to the target.
RL78 supports only a 1-wire connection (TOOL0) between chip and debugger.

Between TOOL0 and VDD a Pull-up-resistor of 1,5 kOhm is recommended.

Products

Order No.Probe
LA-3777Debugger for 78K0R/RL78 (ICD) 

Connector 14 pin


Signal

Pin

 Pin

Signal

    
N/C12GND
N/C34N/C
TOOL056TRESET-
N/C78VDD
EVDD910RESET-
N/C1112GND
RESET-1314GND
    


Target Connector for Debugger Adaption for RL78 Debugger

Connector Type

  • This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".
 
TOP

Half-Size Adapters


Half-Size Adapters for Debuggers



  • 100 mil to 50 mil Adapters
  • Small Footprint for Target Connector






Copyright © 2017 Lauterbach GmbH, Altlaufstr.40, D-85635 Höhenkirchen-Siegertsbrunn, Germany  Impressum
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 10-May-2017