Adaption for OCDS Level 2 TriCore

OCDS-L2 Trace Connector for Tricore OCDS Level 2

Connection Methods

The OCDS-L2 connector is a universal connector for all TriCore derivatives. The connector is used for flow trace and trigger. This connector is available on almost all evaluation boards supporting OCDS-L2 off-chip trace.

Manufacturer AMP
Order No. 104549-6

Link to AMP

Dimensions
Board Layout
Picture


Manufacturer SAMTEC
Order No. QSH-030-01-L-D-A

Link to SAMTEC

Target Connector Orientation AMP40

Target Connector Orientation SAMTEC60

Picture Target Connector SAMTEC60

Manufacturer SAMTEC
Order No. QSH-030-01-L-D-A

Signals

40pin AMP Connector

Signal	Pin		Pin	Signal
CPUCLK	1		2	GND
N/C	3		4	EMUSTAT0
EMUSTAT1	5		6	EMUSTAT2
EMUSTAT3	7		8	EMUSTAT4
N/C	9		10	N/C
N/C	11		12	GND
N/C	13		14	EMUPC0
EMUPC1	15		16	EMUPC2
EMUPC3	17		18	EMUPC4
EMUPC5	19		20	EMUPC6
EMUPC7	21		22	N/C
N/C	23		24	N/C
N/C	25		26	GND
N/C	27		28	EMUBREAK0
EMUBREAK1	29		30	EMUBREAK2
N/C	31		32	N/C
N/C	33		34	N/C
N/C	35		36	VCC
N/C	37		38	N/C
N/C	39		40	GND

60pin SAMTEC Connector

The Samtec connector HW has two edges for correct orientation. One at the corner of pin 2 and one at pin 60.
GND has to be connected to the central ground blade of the connector.
The connector optionally supports the JTAG signals for the OCDS-L1 debugger.

Signal	Pin		Pin	Signal
RESET-	1		2	BREAK2
BRKIN-	3		4	BREAK1
TRST-	5		6	N/C
N/C	7		8	VCCOCDS1
N/C	9		10	BREAK0
OCDS1EN-	11		12	STAT4
TDI	13		14	STAT3
TCK	15		16	STAT2
N/C	17		18	STAT1
N/C	19		20	STAT0
N/C	21		22	N/C
N/C	23		24	N/C
N/C	25		26	N/C
BRKOUT-	27		28	TDO
N/C	29		30	N/C
N/C	31		32	N/C
N/C	33		34	N/C
N/C	35		36	EMUPC7
N/C	37		38	EMUPC6
N/C	39		40	EMUPC5
N/C	41		42	EMUPC4
N/C	43		44	TMS
N/C	45		46	N/C
N/C	47		48	EMUPC3
N/C	49		50	EMUPC2
N/C	51		52	EMUPC1
N/C	53		54	EMUPC0
N/C	55		56	VCCOCDS2
N/C	57		58	OCDS2EN-
N/C	59		60	EMUCLK