Adaption for DSP Tace

Target Adaption for TI DSP trace (cTOOLS)

Target Connector

The adaption could use one 38 pin MICTOR connector or one 60pin SAMTEC connector on the target.



ETM-CON Tyco Electronics WWW Site	Tyco part number	Description
	2-5767004-2	Vertical, surface mount, board to board/cable connector.
	767054-1	Vertical, surface mount, board to board/cable connector.
	767061-1	Vertical, surface mount, board to board/cable connector.
	5767044-1	Right angle, straddle mount, board to board/cable connector.

Signals

Mictor cTOOLS pinout with enable

Signal	Pin		Pin	Signal
N/C	1		2	N/C
N/C	3		4	N/C
N/C	5		6	ETKCLK
DBGRQ	7		8	DBGACK
SRST-	9		10	N/C
TDO	11		12	ETK-VTREF
RTCK	13		14	JTAG-VTREF
TCK	15		16	ETKDATA7
TMS	17		18	ETKDATA6
TDI	19		20	ETKDATA5
TRST-	21		22	ETKDATA4
GND	23		24	ETKDATA3
GND	25		26	ETKDATA2
GND	27		28	ETKDATA1
GND	29		30	GND
GND	31		32	GND
GND	33		34	VCC
ETKDATA9	35		36	ENABLE
ETKDATA8	37		38	ETKDATA0
Connect Pin 39,40,41,42 and 43 to GND

Mictor cTOOLS pinout without enable

Signal	Pin		Pin	Signal
N/C	1		2	N/C
N/C	3		4	N/C
N/C	5		6	ETKCLK0
DBGRQ	7		8	DBGACK
SRST-	9		10	N/C
TDO	11		12	ETM-VTREF
RTCK	13		14	JTAG-VTREF
TCK	15		16	ETKDATA7
TMS	17		18	ETKDATA6
TDI	19		20	ETKDATA5
TRST-	21		22	ETKDATA4
GND	23		24	ETKDATA3
GND	25		26	ETKDATA2
GND	27		28	ETKDATA1
GND	29		30	ETKDATA0
GND	31		32	ETKCLK1
GND	33		34	VCC
GND	35		36	ETKDATA9
GND	37		38	ETKDATA8
Connect Pin 39,40,41,42 and 43 to GND