Adaption for Blackfin The embedded tools company
Debugger Adaption for BlackFin
Target Connector for Debugger Adaption for BlackFin
Half-Size Adapters
 home Products ICD In-Circuit Debugger BDM/JTAG Debuggers Blackfin Debugger Adaption for Blackfin


Adaption for Blackfin



Support
Technical Support



TOP       Debugger Adaption for BlackFin

Connector 14 pin


Signal

Pin

 Pin

Signal

    
GND12EMU-
N/C34GND
VDDIO56TMS
N/C78TCK
N/C910TRST-
N/C1112TDI
GND1314TDO
    


VDDIO This pin is used by the debugger to sense the target I/O voltage and to set the drive levels accordingly. If the sensed voltage level is too low (e.g. target has no power) the debugger powers down its drivers to prevent the target from damage.
TOP       Target Connector for Debugger Adaption for BlackFin

Dimension

Connector Type

  • This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".
TOP       Half-Size Adapters

Half-Size Adapters for Debuggers

  • 100 mil to 50 mil Adapters
  • Small Footprint for Target Connector




Navigation
Copyright © 2008 Lauterbach Datentechnik GmbH, Fichtenstr. 27, D-85649 Hofolding, Germany  Impressum
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice.
Last generated/modified: Mar-7-2008