BDM Connector for S12X The embedded tools company
Debugger Connector
Target Connector Type and Dimension
 home Products ICD In-Circuit Debugger BDM/JTAG Debuggers MCS12 Debugger BDM Connector for S12X


BDM Connector for S12X



Support
Technical Support



TOP       Debugger Connector

Connector for MCS12X


Signal

Pin

 Pin

Signal

    
BKGD12GND
ECLK34RESET-
N/C56VCC
    

The signal ECLK on pin three must not be connected to the CPU if the ECLK frequency is higher than 25 MHz. The signal VCC on pin six is used to sense if the target has power and to adjust the output drivers to the target's voltage level.
TOP       Target Connector Type and Dimension

Dimension

Connector Type

  • This is a standard 6 pin double row (two rows of 3 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 12.5mm/0.5".




Navigation
Copyright © 2008 Lauterbach Datentechnik GmbH, Fichtenstr. 27, D-85649 Hofolding, Germany  Impressum
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice.
Last generated/modified: Mar-7-2008