|
Debugger Adaption for Renesas Electronics (NEC) 78K0R Debugger |
The debugger is connected via 16 pin double row connector to the target. Currently only 2-wire connection (TOOL0 + TOOL1) between target and debugger is supported. If single wire connection is necessary, please contact Technical Support.
Between TOOL0 and VDD a Pull-up-resistor of 1,5 kOhm is recommended.
 Connector 16 pin
|
Signal
| Pin
| | Pin
| Signal
|
|---|
| | |  | | |
| VSS | 1 |  | 2 | RESET- |
| TOOL0 | 3 | | 4 | VDD |
| N/C | 5 | | 6 | N/C |
| N/C | 7 | | 8 | N/C |
| N/C | 9 | | 10 | N/C |
| N/C | 11 | | 12 | N/C |
| N/C | 13 | | 14 | FLMD0 |
| TRESET- | 15 | | 16 | TOOL1 |
| | |  | | |
Target Connector for Debugger Adaption for 78K0R Debugger
Connector Type
- This is a standard 16 pin double row (two rows of 8 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 25.5mm/1".
|
Debugger Adaption for Renesas Electronics RL78 Debugger |
The debugger is connected via 14 pin double row connector to the target. RL78 support only a 1-wire connection (TOOL0) between chip and debugger.
Between TOOL0 and VDD a Pull-up-resistor of 1,5 kOhm is recommended.
Connector 14 pin
|
Signal
| Pin
| | Pin
| Signal
|
|---|
| | | | | |
| N/C | 1 | | 2 | GND |
| N/C | 3 | | 4 | N/C |
| TOOL0 | 5 | | 6 | TRESET- |
| N/C | 7 | | 8 | VDD |
| EVDD | 9 | | 10 | RESET- |
| N/C | 11 | | 12 | GND |
| RESET- | 13 | | 14 | GND |
| | | | | |
Target Connector for Debugger Adaption for RL78 Debugger
Connector Type
- This is a standard 14 pin double row (two rows of 7 pins) connector (pin to pin spacing: 2.54mm/0.100").
- If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".
|
Half-Size Adapters |
- 100 mil to 50 mil Adapters
- Small Footprint for Target Connector
|
|
Half-Size Adapters for Debuggers
Debugger Adaption for Renesas Electronics (NEC) 78K0R Debugger