JTAG/COP Connector for PPC603/740/750/8240/8260...


The embedded tools company




Support
Technical Support
 

Target Adaption for Debugger Connector


Connectors for PPC603X - PPC750 - MPC5200 - MPC512X - MPC74XX - MPC82XX - MPC83XX - MPC86XX - PA6T

Connector 16 pin


Signal

Pin

 Pin

Signal

    
TDO12(QACK-)
TDI34TRST-
(QREQ-)56JTAG-VREF
TCK78(PRESENT-)
TMS910N/C
(SRESET-)1112GND
HRESET-1314N/C (KEY PIN)
(CKSTOP-)1516GND
    

  • Signals in brackets are not necessary for debugging, but it is recommended to connect those signals if available.
  • Pin 8 will be permanently driven to VCCS level by the debugger.
  • Signals which are not available should be left unconnected on the debug connector.
  • Pin 6 (JTAG-VREF) must match the JTAG I/O voltage of the processor. JTAG-VREF should have a resistance less than 5kOhm for 3.0~5.0V, less than 2kOhm for 1.8~3.0V.
  • Debug cables from March 2004 and older (blue ribbon cable, 3.3V..5V only): Pin 6 (VCC) should be directly connected to VCC.

 

Target Connector


Dimension

Connector Type

  • This is a standard 16 pin double row (two rows of 8 pins) connector (pin to pin spacing: 2.54mm/0.100").
  • If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 25.5mm/1".
 

Half-Size Adapters


Half-Size Adapters for Debuggers



  • 100 mil to 50 mil Adapters
  • Small Footprint for Target Connector






Copyright © 2024 Lauterbach GmbH, Altlaufstr.40, 85635 Höhenkirchen-Siegertsbrunn, Germany   Impressum     Privacy Policy
The information presented is intended to give overview information only.
Changes and technical enhancements or modifications can be made without notice. Report Errors
Last generated/modified: 07-Mar-2024