JTAG Connector for MPC5xxx (OnCE)

Adaption for MPC5XXX/SPC5XXX OnCE Debug Connector

Products

Order No.	Probe

Connector 14 pin

Signal	Pin		Pin	Signal
TDI	1		2	GND
TDO	3		4	GND
TCK	5		6	GND
N/C	7		8	N/C
RESET-	9		10	TMS
VDD TARGET	11		12	GND
(RDY-)	13		14	(JCOMP-)

Dimension

Connector Type

• This is a standard 14 pin double row (two rows of seven pins) connector (pin to pin spacing: 2.54mm/0.100").
  
  
• If terminal strip without shroud is used, the spacing marked with "A" must be a minimum of 23mm/0.9".

JTAG connector recommendations

• TDI, TDO, TCK, TMS and JCOMP- should be connected directly to the CPU. Don't connect serial resistors or RC terminations to those signals.
  
  
• Avoid routing the JTAG signals close to the NEXUS signals.
  
  
• Connect VDD to the voltage which also supplies the processor's JTAG signals (esp. TDO). VDD can be connected directly to the target's power supply, or optional with a resistor < 5kOhm
  
  
• The RDY- signal (pin 13) is optional.
  If the signal is not available, or can not be connected because of other reasons, the RDY- pin on the debug connector should be connected to GND.
  If the RDY- signal on the debug connector is not connected, set SYStem.Option.NOJTAGRDY ON.
  
  
• If the signal JCOMP (pin 14) is not available on the used processor/package type, leave the JCOMP pin on the debug connector unconnected.
  
  
• We recommend to follow Freescale's Application Note AN2614.

Debug Cable Information

• When the debugger is inactive (SYStem.Mode.DOWN and NoDebug), all output pins of the debug cable are tri-stated (hot-plug capability)
  
  
• During the debug session: TDI, TCK, TMS and JCOMP- are driven to both low and high levels. Only RESET is an open-drain output. The voltage level of a pin driven to high is the same soltage level as connected to VDD target (pin 11).
  
  
• All output signals of the debug cable have a 47 Ohm serial termination. Usually no further termination is needed on the target hardware.
  
  
• Maximum supported voltage range (check debug cable's serial number CYYMMxxxxxx):
  • Debug cable produced before 09/2009: 1.8-5.5V
  • Debug cable produced 09/2009 or later: 0.9-5.5V
  
  
• Input impedance on VDD target (pin 11):
  • Debug cable produced before 09/2009: >45 kOhm
  • Debug cable produced 09/2009 or later: >90 kOhm
  
  
• IEEE 1149.7 (aka cJTAG) supported by debug cables produced 09/2009 or later.

Half-Size Adapters

Half-Size Adapters for Debuggers

100 mil to 50 mil Adapters Small Footprint for Target Connector